 |
No copilot panel
installed yet. Installed black vinyl to cover the ugly portions of the
cockpit and the motion system. Also, had to disassemble my base about
3 weeks ago, so I carpeted my Sim Room. Sim room is 16 x 18 feet with
12 foot ceiling
If I had it to do again, I would have probably built the “cockpit” from scratch. Converting an actual Beech 18 was (and still is) a challenge!
|
|
Flight Link Radio Stack installed, not completely working yet tho!
|
|
|
Motion Base -
Galil card is just to the left, not permanently mounted yet. Need to find a
project box for it.
I quit using the Classicflight Motion System as the feedback wasn't working the way it needed to be. I hired Mark Barry of http://www.inmotionsimulation.com and bought a Galil http://www.galilmc.com controller card which hooks to the flight simulation via ethernet and Inmotion's software.
|
|
|
Picture taken from left side, The center post has been significantly “beefed up” |
 |
Single cylinder with the http://spaceagecontrols.com string encoder (blue) installed. This high precision position feedback is mandatory for a quality motion base! I am very impressed with Space Age's quality. I may change my flight controls over to their string encoders also. |
